Chauvet Tiger DMX 60 Manual do Operador descarregar pdf (Página 136)

Page 168 - 7. Chases

Pearl 2008 Manual - 16th July 2007

2> Press E [Sound to Light] to select Low, Mid or High trigger.

3> Turn the key to Run mode and press E [Enable sound to light]

(this is the global Sound to Light enable).

3> When the chase is turned on, it will step in time to the sound

signal

4> Press E, again, to turn off sound activation.

• Turn the chase links Off and set fade times to zero to get a true

sound to light chase.

• You can make some linked steps and some unlinked steps to give

a chase which runs on a few steps for every audio pulse.

• The sensitivity of the audio input can be set using an internal PCB

jumper to enable use of a microphone rather than line level audio.

See page

110.

7.7 Advanced options

7.7.1 Chase options

Each chase has options which can be set to affect the way it runs. Press

A [Chase Parameters]. You need to have a chase “connected”, or the

softkey will not do anything. The options you set are individual for each

chase.

The options are:

A [Save Speed] - saves the current speed of the chase (set using the

left hand wheel)

B [Save Direction] - save the direction of the chase (set using the

direction / bounce buttons or options, see below)

C [Normal / Random] - turn on random mode (steps are executed in

random order) - press to change the mode. Turn off random mode

when editing a chase, or you won’t know which step you are going

to get next.

D [Stop on final step] - makes the chase stop on the final step. If the

final step is a blackout, the chase will appear to turn itself off, so

you can just press Go whenever you want to make it happen again

E [Sound to light] – as described above

F [More…] – Gives a second screen of options

A [Fader start options] - (press the button to cycle through the

options):

Fader will reload chase (every time you turn on the chase it starts at

step 1)

Fader stops, go to start chase (the chase will not run until you have

pressed Go after you turn on the chase)

Fader stops/starts chase (every time you turn on the chase it continues

from where it left off)

B [Skip times options] – Allows you to skip the first wait and/or fade

of a chase. You often want to do this so the chase starts as soon as

you raise the fader. (Press the button to cycle through options)…

Skip first wait time (The wait time is missed when the chase is first

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 205 206

Comentários a estes Manuais

Sem comentários

Chauvet Tiger DMX 60 Manual do Operador Página 136

Comentários a estes Manuais