
WELL™ 2.0 User Manual Rev. 01 Page 9 of 28
4. Operation
Notes
• Always operate the unit in an upright position.
• Never tilt the unit more than 10º.
• Only use the retractable foot to tilt the unit.
• Do not operate the unit in a sealed enclosure or in an area without air circulation.
• Turn the battery storage switch on.
• Push the On/Off switch on the top for more than three seconds (the built-in red LED
will illuminate solid).
• When not connected to the battery charger, the power status LED indicates the
amount of remaining battery charge, as follows:
Green: >70 % (100~70% charge)
Yellow: >20 % (69~21 % charge)
Red: Empty (20~0 % charge)
• Push the On/Off switch on the top for more than three seconds (the built-in red LED
will turn off).
• If storing the unit for more than seven days after recharging it, also turn the battery
storage switch off.
• Place the fixture on a flat, sturdy surface.
• Release the extensible foot by shifting the foot release lever.
• Keep the lever shifted to adjust the angle and release the lever.
• Do not allow the unit to tilt further than 10º.
• Use the screws on the unit’s front panel to adjust the angle of the LED panels.
• The screw on the left adjusts the rear LED panel.
• The screw on the right adjusts the front LED panel.
After being prompted, enter the following password by pressing:
<UP>, <DOWN>< <UP>, <DOWN>, <ENTER>
The password cannot be changed and must be used when prompted.
Storage Notes
• Always store the unit in an upright position (≤ 10º tilt).
• Recharge the battery to full capacity before storing the unit.
• Store charged unit(s) in a dry environment, away from direct sunlight.
• Turn the battery storage switch off if storing the unit for more than seven days.
Comentários a estes Manuais