Chauvet DMX-690 Manual do Utilizador

Snapshot Ok on Dimmer Outdoor OK Sound Activated DMX512 Master/Slave 115V/230V Switch Replaceable Fuse User Serviceable Duty Cycle DMX-690 In

Fixture Linking You will need a serial data link to run light shows of one or more fixtures using a DMX-512 controller or to run synchronized shows on

3-PIN TO 5-PIN CONVERSION CHART th a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter. CHAUVET Model No: DMX5M, or DMX5F. 3 P

Mounting ORIENTATION This fixture may be mounted in any position provided there is adequate room for ventilation. RIGGING Hanging Clamp It is impor

4. OPERATING INSTRUCTIONS Navigating the Control Panel Access control panel functions using the four panel buttons located directly underneath the LCD

Menu Map Intimidator Spot 2.0 HTI Manual 14 2007-01-24/09:36

Menu Functions User Configurations MENU OPTION DESCRIPTION DMX: The fixture will be controlled by a DMX signal coming from a DMX controller. The st

TO CHANGE THE PAN RANGE: 1) Press <MODE/ESC> until , , or is displayed.. 2) Use the <UP> and <DOWN> buttons to scroll through t

OperationStand-Alone Mode (Sound-Active, Auto Mode, Easy Controller): This mode allows a single unit to run to the beat of the music, or the unit will

DMX Mode This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer on pag

DMX Channel Values (8-bit mode) CHANNEL VALUE FUNCTION 1 000 Ù 255 Pan 0 – 540 (128 = halfway point) 2 000 Ù 255 Tilt 0 – 270 (128 = halfway point)

TABLE OF CONTENTS 1. BEFORE YOU BEGIN...

General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal swit

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-1

Returns Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled

Technical Specifications WEIGHT & DIMENSIONS Length...

1. BEFORE YOU BEGIN What is included ¾ 1 x Intimidator Spot 2.0 HTI™ ¾ 150W HTI Lamp ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructio

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of

2. INTRODUCTION Features • 6 to 8-channel DMX-512 moving yoke • Pan: 540° / tilt: 270° • Variable strobe/shutter • Color wheel: 7 colors + white Ra

Product Overview Control Panel DMX Output Connector Yoke Rear of Base AC Power Input & Fuse Holder Easy Controller Connector DMX Input Connector

3. SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. A 150W HTI lamp is included. Warning! When replacing t

Lamp Alignment How-To Often, after a new installation of a lamp, you will find that there is an uneven field of light or what is refered to as a hot s

Replacing Gobos 1) Remove the four screws indicated in figure A to remove the back of the head. Figure A Figure B Figure C Figure D 2) Remove the fo